BLENDA^®-TEX is a water-dilutable, alkali-resistant, white pigmented and low-odour insulating and barrier primer for problematic substrates. It prevents the formation of stains on subsequent coats and equalises substrates with different levels of absorption. The insulating effect is excellent for residues of nicotine, soot, tar, grease, water stains, fire damage, felt pens, etc. BLENDA^®-TEX has a good adhesion and hardening effect, is block resistant and non-yellowing.

DUROTEX is an unsaponifiable, white pigmented and solvent-containing insulating and barrier primer for problematic substrates. It prevents the formation of stains on subsequent coats and equalises substrates with different levels of absorption. The insulating effect is excellent for residues of nicotine, soot, tar, grease, water stains, fire damage, felt pens, etc. DUROTEX has a good adhesion and hardening effect, is block resistant and non-yellowing.

Quick-drying, highly covering and adhesive insulating and barrier primer for problematic substrates. UNI-TEX prevents stains from penetrating through subsequent coats and levels differently absorbent surfaces. The insulating effect is excellent against felt-tip pens, water stains, tanning agents, mould, nicotine, soot, oil, tar, grease, rust, etc. and allows rapid overpainting with water-thinnable wall and ceiling paints as well as solvent-based paints.

Thin-bodied water-based filler with mineral fillers, plastic-bonded. Ideally suited for pre-treating damp walls inside or outside before painting or wallpapering. Stops moisture and protects the final coatings. Hides micro cracks. Forms a flexible film. Can be applied with a brush, roller or spray gun.

Removes efflorescence (saltpetre etc.) on natural stone, clinker, brick, concrete and plaster. Cover acid-sensitive surfaces (e.g. marble, artificial stones).

By silicification, soluble lime salts are chemically converted into water-insoluble calcium fluoride. The penetration of water, lyes and acids is prevented. Protects walls and facades from weathering and frost damage. Stain isolation of water edges, smoke, soot, nicotine stains, consolidation of old and new plaster. No flaking and saponification of the paint, therefore achievement of even, stain-free surfaces. Against efflorescence on masonry and plaster. Prevents mould and dry rot. Neutralization of active lime and cement plaster. Important for new dispersion coatings to prevent colour changes. Especially important for treatments with silicate coatings. Conservation of artificial, natural and limestone stones.

XENOSAL is a transparent insulating agent to combat efflorescence (salpeter, etc.) on masonry. The magnesium and zinc compounds effectively neutralise the affected surfaces and can be used to apply a new plaster or paint finish. Due to the complexity and problems of salt efflorescence, even XENOSAL fluorine insulating agent cannot guarantee further efflorescence. However, XENOSAL offers an efficient and cost-effective renovation without the need for expensive damage analysis and wall renovation.

DUROXIM is a water-thinnable and blow-odour concrete glaze for exterior and interior use. The colourless or glazed coating gives the surface an even character while preserving the natural exposed concrete structure. DUROXIM is outstandingly weather-resistant, breathable as well as resistant to saponification and yellowing and provides lasting protection for the substrate against aggressive environmental and weathering influences.

XENOSIL is a water-dilutable, transparent and siliconized impregnation with a good penetration capacity and a very good water-repellent effect. XENOSIL levels and binds unevenly absorbent surfaces and protects against efflorescence and algae growth. XENOSIL prevents the penetration of moisture without reducing the water vapour permeability.

XENOROX is a solvent-based, transparent silicone impregnation with high penetration and excellent water repellency. XENOROX prevents the penetration of moisture and protects against efflorescence without reducing the water vapour permeability. XENOROX silicone impregnate LH-454 is not film-forming (no surface effect) and the hardening effect is low.

XENOLIN is a water-based and ready-to-use impregnating solution with excellent water and dirt repellent properties. Due to these properties, the growth of microorganisms on substrates treated with XENOLIN is greatly reduced. At the same time, a very good soil-repellent effect is achieved against sunscreens, oils as well as foodstuffs such as mustard, ketchup, mayonnaise, fruit juices, red wine, etc. Excellent dirt-repellent results are also achieved with engine and waste oils. XENOLIN penetrates deep into the substrate and forms a breathable and dirt-repellent surface protection. XENOLIN is not film-forming and does not significantly alter the inherent color of the substrate.

The Anti Graffity cleaning agent infiltrates spray paints, paints and felt-tip pens on all solvent-resistant surfaces (such as metal, glass, wood, tiles, unpainted concrete, clinker bricks and natural and artificial stones) and thus serves to remove paint smears and unwanted graffiti. In the case of painted or varnished surfaces, the substrate can also be detached. In the case of non-solvent resistant substrates, compatibility must be checked. It is recommended to protect the cleaned surfaces with Anti Graffity Finish or Anti Graffity Protective Varnish.

Anti Graffity Finish is a sacrificial protection system for absorbent surfaces that dries matt. It is a pore-lined and highly breathable protective coating that must be partially renewed after the paint smears have been removed. At the same time, Anti Graffity Finish prevents water and pollutants from penetrating into the substrate. The material is silicone- and wax-free and can therefore be painted over at any time. After a period of 4?5 years, the system must be renewed. Anti Graffity Finish can be applied to all absorbent surfaces such as facades, plasters, full thermal insulation, concrete, clinker, natural stone, marble, wood, etc. Not suitable for hydrophobic and water-repellent surfaces. Surfaces which are exposed to (rearward) moisture penetration should not be coated (e.g. free-standing walls).

Anti Graffity Protective Varnish is a permanent system for absorbent and non-absorbent surfaces, which dries with a silky gloss. Anti Graffity protective lacquer is a permanent system that forms a silky gloss film. At the same time, the material hinders the penetration of water and pollutants into the subsoil. The protective film is frost de-icing salt resistant according to the WTA guideline. From this protective film, paint smears and felt tip pens can be removed several times with Geiger Anti Graffity Cleaner (at least 10–15 cleanings possible) before it has to be repaired. The water vapor diffusivity is not significantly changed (Sd mean value 0,6). Anti Graffity protective lacquer can be applied on non-absorbent surfaces as well as on all absorbent surfaces.

BLENDA^®-DUR is a film-forming, water-dilutable and transparent 2-component polyurethane protective paint for exterior and interior use. BLENDA^®-DUR forms a permanent surface film with excellent chemical and mechanical resistance and prevents spray paint, felt-tip pens and other contaminants from adhering to it. BLENDA^®-DUR has excellent light and weather stability, prevents the penetration of water and pollutants and shows excellent resistance to diluted chemicals, detergents, hand perspiration, hydraulic oils, oils, greases, etc. BLENDA^®-DUR coatings can be cleaned easily and repeatedly with GEIGER anti-graffiti cleaner without the need to renew the protective coating or to change the color.

BLENDA^®-LUX is a film-forming, water-dilutable and pigmented 2-component polyurethane protective paint for exterior and interior use. BLENDA^®-LUX forms a permanent surface film with excellent chemical and mechanical resistance and prevents spray paint, felt-tip pens and other contaminants from adhering to it. BLENDA^®-LUX has excellent light and weather stability, prevents the penetration of water and pollutants and shows excellent resistance to diluted chemicals, detergents, hand perspiration, hydraulic oils, oils, greases, etc. BLENDA^®-LUX coatings can be cleaned easily and repeatedly with GEIGER anti-graffiti cleaner without the need to renew the protective coating or to change the color.

BRILALUX is a film-forming, chemically curing 2-component acrylic polyurethane (DD) protective paint for exterior and interior use. BRILALUX forms a permanent surface film with excellent chemical and mechanical resistance and prevents spray paint, felt-tip pens and other contaminants from adhering to it. BRILALUX has excellent light and weather stability, prevents the penetration of water and pollutants and shows excellent resistance to diluted chemicals, detergents, hand perspiration, hydraulic oils, oils, greases, etc. BRILALUX coatings can be cleaned easily and repeatedly with GEIGER anti-graffiti cleaner without the need to renew the protective coating or to change the color.

ECLON SIL 2K-anti-graffiti enamel gloss is a high solid 2-component paint based on epoxy silicone resin. ECLON SIL is especially characterized by high resistance to moisture, salt, industrial dirt, solvents and many chemicals. The very hard, chemically and mechanically resistant surface of ECLON SIL 2K-anti-graffiti enamel gloss prevents spray paint, felt-tip pen markings, glue and other soiling from adhering to it. This allows their removal without any problems and without leaving any traces, even after repeated cleaning. ECLON SIL has excellent weather and chemical resistance, good filling power, does not wrinkle or yellow.

ECLON SIL 2K-anti-graffiti enamel silk gloss is a high solid 2-component paint based on epoxy silicone resin. ECLON SIL is especially characterized by high resistance to moisture, salt, industrial dirt, solvents and many chemicals. The very hard, chemically and mechanically resistant surface of ECLON SIL 2K-anti-graffiti enamel silk gloss prevents spray paint, felt-tip pen markings, glue and other soiling from adhering to it. This allows their removal without any problems and without leaving any traces, even after repeated cleaning. ECLON SIL has excellent weather and chemical resistance, good filling power, does not wrinkle or yellow.

ECLON SIL 2K-anti-graffiti enamel satin matt is a high solid 2-component paint based on epoxy silicone resin. ECLON SIL is especially characterized by high resistance to moisture, salt, industrial dirt, solvents and many chemicals. The very hard, chemically and mechanically resistant surface of ECLON SIL 2K-anti-graffiti enamel satin matt prevents spray paint, felt-tip pen markings, glue and other soiling from adhering to it. This allows their removal without any problems and without leaving any traces, even after repeated cleaning. ECLON SIL has excellent weather and chemical resistance, good filling power, does not wrinkle or yellow.

ECLON SIL 2K-anti-graffiti varnish clear gloss is a high solid 2-component paint based on epoxy silicone resin. ECLON SIL is especially characterized by high resistance to moisture, salt, industrial dirt, solvents and many chemicals. The very hard, chemically and mechanically resistant surface of ECLON SIL 2K-anti-graffiti varnish clear gloss prevents spray paint, felt-tip pen markings, glue and other soiling from adhering to it. This allows their removal without any problems and without leaving any traces, even after repeated cleaning. ECLON SIL has excellent weather and chemical resistance, good filling power, does not wrinkle or yellow.

Ideally suited as a solvent-free coating for the protection of all wallpapers, wall paints of any kind, as well as for natural and artificial stone. GEIGER wallpaper protection makes paints and wallpapers washable, scrub-resistant, crystal clear and quick-drying. GEIGER wallpaper protection does not yellow and is a UV-resistant protection against dirt and dust.

BRILASUN is a solvent-based, quick-drying and white glazing sun protection paint for covering glass areas against sunlight. BRILASUN produces a matt, light-protective and non-yellowing coating with excellent adhesion, scratch resistance and weather resistance.

ECOFLAM is an aqueous, low-odour and clear salt impregnation for the flame-retardant finishing of textiles made of natural fibres as well as absorbent decorative materials indoors, according to fire protection class B1 / M1. The treated materials are flame-retardant and non-flammable gases develop in case of fire. The material carbonizes, but does not continue to burn independently.

BLENDA^®-PLAST is a fast-drying, non-stick plastic paint for exterior and interior use. A viscoplastic plastic skin is formed, which thanks to its special formulation only adheres so well that it can be pulled off again like a film at any time. BLENDA^®-PLAST is suitable for use on many materials such as metals, plastics, mineral substrates, etc. – provided that they have a non-porous and smooth surface.

BRICAPLAST is a fast-drying, non-stick plastic paint for exterior and interior use. A viscoplastic plastic skin is formed, which thanks to its special formulation only adheres so well that it can be pulled off again like a film at any time. BRICAPLAST is suitable for use on many materials such as metals, plastics, mineral substrates, etc. – provided that they have a non-porous and smooth surface.